D-Link xStack DGS-3620 Series Reference Manual page 312

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Neighbor Address
Peer Group Name
EBGP Multihop (1-255)
Weight (0-65535)
Update Source Action
Interface Name
Address Family
Send community
Next Hop Self
Soft Reconfiguration
Inbound
Remove Private AS
Figure 6-153 BGP Neighbor General Settings window
Description
Click the radio button and use the drop-down menu to select the address of the BGP
speaking neighbor.
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Enter the TTL of the BGP packet sent to the neighbor.
Enter a value for weight. The valid range is from 0 to 65535. If this is not specified,
the routes learned through another BGP peer will have a default weight of 0. Routes
sourced by the local router have a weight of 32768. It cannot be changed. Tick the
Default check box to use the default weight value.
Enter an interface to be used by BGP sessions for TCP connection. By default, this
parameter is not set.
Enter the IP interface name used.
Select the address family that will be configured here. Options to choose from are
IPv4 Unicast and IPv6 Unicast.
Use the drop-down menu to select Standard or None. This specifies the communities
attribute to be sent to the BGP neighbor. Standard means only standard communities
will be sent and None means no communities will be sent. The default value is None.
Enable or disable the next hop self attribute. By default, this setting is Disabled
Enable or disable the inbound soft reconfiguration function. By default, this setting is
Disabled.
If this setting is set to Enabled, the private AS number in the AS path attribute of the
BGP update packets will be dropped. By default, the setting is Disabled.
311