Dos Attack Prevention Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Host Name
Host IP
Click the Edit button to re-configure the specific entry.
Click the Apply button to accept the changes made.
NOTE: To set the SSH User Authentication Mode parameters on the Switch, a User Account must be
previously configured.

DoS Attack Prevention Settings

On this page, the user can configure the prevention of each DoS attacks. The packet matching will be done by
hardware. For a specific type of attack, the content of the packet will be matched against a specific pattern.
To view this window, click Security > DoS Attack Prevention Settings as shown below:
The fields that can be configured or displayed are described below:
Parameter
DoS Type Selection
public key on a SSH server for authentication.
Enter an alphanumeric string of no more than 32 characters to identify the remote
SSH user. This parameter is only used in conjunction with the Host Based choice in
the Auth. Mode field.
Enter the corresponding IP address of the SSH user. This parameter is only used in
conjunction with the Host Based choice in the Auth. Mode field.
Figure 9-86 DoS Attack Prevention Settings window
Description
Here the user can select the appropriate DoS Attack prevention types.
Land Attack - Specifies that the DoS attack prevention type will be set to prevent
LAND attacks.
Blat Attack - Specifies that the DoS attack prevention type will be set to prevent
BLAT attacks.
TCP Tiny Frag Attack - Specifies that the DoS attack prevention type will be set to
498