Wac User Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
HTTP(S) Port (1-65535)
Trap State
Click the Apply button to accept the changes made for each individual section.
NOTE: A successful authentication should direct the client to the stated web page. If the client does
not reach this web page, yet does not receive a Fail! Message, the client will already be
authenticated and therefore should refresh the current browser window or attempt to open a
different web page.
NOTE: The WAC virtual IP address should be configured before enabling WAC (because WAC will not
work correctly if the virtual IP address is not set.). A warning message like "Warning! WAC
virtual IPv4 or IPv6 address is not configured." will be prompted even when enabling WAC
successfully.

WAC User Settings

Users can view and set local database user accounts for Web authentication.
To view this window, click Security > Web-based Access Control (WAC) > WAC User Settings as shown below:
The fields that can be configured are described below:
Parameter
User Name
VLAN Name
VID (1-4094)
Password
RADIUS server must have already been pre-assigned by the administrator using the
Authentication RADIUS Server Settings window.
Enter a HTTP port number. Port 80 is the default.
HTTP – Specifies that the TCP port will run the WAC HTTP protocol. The default
value is 80. HTTP port cannot run at TCP port 443.
HTTPS – Specifies that the TCP port will run the WAC HTTPS protocol. The default
value is 443. HTTPS cannot run at TCP port 80.
Select to enable or disable the WAC trap state.
Figure 9-39 WAC User Settings window
Description
Enter the user name of up to 15 alphanumeric characters of the guest wishing to
access the Web through this process. This field is for administrators who have selected
Local as their Web-based authenticator.
Click the button and enter a VLAN Name in this field.
Click the button and enter a VID in this field.
Enter the password the administrator has chosen for the selected user. This field is
case-sensitive and must be a complete alphanumeric string. This field is for
451