D-Link xStack DGS-3620 Series Reference Manual page 313

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Allow AS in
Allow AS in Value (1-
10)
Default Originate State
Route Map Name
Click the Apply button to accept the changes made.
BGP Neighbor Timer Settings
This window is used to configure BGP neighbor timer settings.
To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Timer Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Neighbor Address
Peer Group Name
Advertisement Interval
(0-600)
Keepalive (0-65535)
If this is Enabled, the BGP router's self AS is allowed in the AS path list. By default,
this setting is Disabled. If no number is supplied, the default value of three times is
used.
Enter an Allow AS in Value between 1 and 10.
Enable or disable the default originate function. By default, this setting is Disabled.
Enter a Route Map Name of a maximum of 16 characters.
Figure 6-154 BGP Neighbor Timer Settings window
Description
Click the radio button and use the drop-down menu to select the address of the BGP
speaking neighbor.
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Enter the interval at which the BGP process sends update messages to its peer. The
valid value is from 0 to 600. If this value is set to zero, the update or withdrawn
message will be sent immediately. The default value for IBGP peers is 5 seconds and
for EBGP peers it is 30 seconds. When the Default check box is ticked, the neighbor
specific advertisement interval setting will be returned to the default setting.
Enter the interval at which a keepalive message is sent to its peers. If the two routers,
that build a BGP connection, have different keepalive timers, the smaller keepalive
timer will be unset. The valid value is from 0 to 65535. If the keepalive is set to zero,
then the keepalive message will not be sent out. Tick the Default check box to clear
the specification of the neighbor specific keepalive setting.
312