D-Link xStack DGS-3620 Series Reference Manual page 193

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
LLDP-MED Log State
Fast Start Repeat Count
(1-10)
Click the Apply button to accept the changes made for each individual section.
LLDP-MED Port Settings
This window is used to enable or disable transmitting LLDP-MED TLVs.
To view the following window, click L2 Features > LLDP> LLDP-MED > LLDP-MED Port Settings, as shown
below:
Figure 5-123 LLDP-MED System Settings window
Description
Click the radio buttons to enable or disable the log state of LLDP-MED events.
Enter a value between 1 and 10 for the fast start repeat count. When an LLDP-
MED Capabilities TLV is detected for an MSAP identifier not associated with an
existing LLDP remote system MIB, then the application layer shall start the fast
start mechanism and set the 'medFastStart' timer to 'medFastStartRepeatCount'
times 1. The default value is 4.
192