D-Link xStack DGS-3620 Series Reference Manual page 568

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
Port
Time Interval
Record Number
ExDefer
CRC Error
LateColl
ExColl
SingColl
Figure 12-13 TX Error Analysis window (table)
Description
Select the unit you wish to configure.
Use the drop-down menu to choose the port that will display statistics.
Select the desired setting between 1s and 60s, where "s" stands for seconds. The
default value is one second.
Select number of times the Switch will be polled between 20 and 200. The default value
is 200.
Counts the number of packets for which the first transmission attempt on a particular
interface was delayed because the medium was busy.
Transmit FCS Error Counter - Incremented for each frame transmitted that is between
64 byte inclusive to cntMaxSize (cntMaxSize + 4 for tagged VLAN) bytes in length and
contains a Frame Check Sequence Error. Note: This counter is not incremented if a
cell error is detected.
Counts the number of times that a collision is detected later than 512 bit-times into the
transmission of a packet.
Excessive Collisions. The number of packets for which transmission failed due to
excessive collisions.
Single Collision Frames. The number of successfully transmitted packets for which
567