D-Link xStack DGS-3620 Series Reference Manual page 624

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Event description: port linkdown
Log Message: Port <port> link down
Parameters description:
port: Represents the logical port number.
DDM Event description: DDM exceeded or recover from DDM alarm threshold
Log Message: DDM Port <[unitID:]portNum> optic module [thresholdType] [exceedType] the
[thresholdSubType] alarm threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of the following values:
temperature, supply voltage, bias current, TX power, RX power.
exceedType: indicate exceed threshold or recover to normal event, the value should be
"recovered from" or "exceeded"
thesholdSubType: the DDM threshold sub type, the value should be "high" or "low".
Event description: DDM exceeded or recover from DDM warning threshold
Log Message: DDM Port <[unitID:]portNum> optic module [thresholdType] [exceedType] the
[thresholdSubType] warning threshold
Parameters description:
unitID: The unit ID.
portNum: The port number.
thresholdType: the DDM threshold type. The value should be one of the following values:
temperature, supply voltage, bias current, TX power, RX power.
exceedType: indicate exceed threshold or recover to normal event, the value should be
"recovered from" or "exceeded"
thesholdSubType: the DDM threshold sub type, the value should be "high" or "low".
BPDU Event description: BPDU attack happened.
Log Message: Port<[unitID:]portNum> enter BPDU under protection state (mode: drop / block
/ shutdown)
Parameters description:
unitID: The unit ID.
portNum: The port number.
mode:The BPDU currnt state
Event description: BPDU attack automatically recover.
Log Message: Port <[unitID:]portNum> recover from BPDU under protection state
automatically
Parameters description:
unitID: The unit ID.
portNum: The port number.
Event description: BPDU attack manually recover.
Log Message: Port<[unitID:]portNum> recover from BPDU under protection state
automatically
Parameters description:
unitID: The unit ID.
portNum: The port number.
External Alarm Event description: External alarm occurred
Log Message: [Unit <unitID>] External Alarm Channel <channel_id> : <alarm_message>
Parameters description:
unitID: The unit ID.
channel_id: Represent the channel ID detected the external alarm
alarm_message: Alarm message when alarm occurred, this is configurable by user.
The default alarm message is defined in "Default Setting" Chapter.
Event description: External alarm occurred
Log Message: External Alarm Channel <channel_id> : <alarm_message>
Parameters description:
channel_id: Represent the channel ID detected the external alarm
alarm_message: Alarm message when alarm occurred, this is configured by the user.
RIPng
Event description: The RIPng state of interface changed
Log Message: RIPng protocol on interface <intf-name> changed state to <Enabled |
Disabled>
Parameters description:
intf-name: Interface name.
SSH Event description: Successfully download client public keys.
Log Message: SSH client public keys file was upgraded successfully (Username:
<username>, IP: < ipaddr | ipv6address >)
Parameters description:
username: The username upgraded client public keys file.
ipaddr: Represent client IP address.
ipv6address: Represent client IP address.
Peripherals Event description: Right Side Recovered.
Log Message: Unit <id>, Right Side Fan <id> recovered.
623
Informational
Critical
Warning
Informational
Informational
Informational
Critical
Critical
Informational
Informational
Critical