Dhcpv6 Relay - D-Link DGS-3000 Series Reference Manual

To view this window, click Network Application > DHCP > DHCP Server > DHCP Conflict IP as shown below:
Click the Clear All button to remove all the entries listed in the table.

DHCPv6 Relay

DHCPv6 Relay Global Settings
This window is used to configure the DHCPv6 relay function on the Switch.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Global Settings as
shown below:
The fields that can be configured are described below:
Parameter
DHCPv6 Relay State
DHCPv6 Relay Hops
Count (1-32)
Click the Apply button to accept the changes made for each individual section.
DHCPv6 Relay Settings
This window is used to configure the DHCPv6 relay state of one or all of the specified interfaces, and add or display a
destination IPv6 address to or from the switch's DHCPv6 relay table.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Settings as shown
below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 9-15 DHCP Conflict IP window
Figure 9-16 DHCPv6 Relay Global Settings window
Description
Click to enable or disable the DHCPv6 relay function.
Enter the number of relay agents that have to be relayed in this message. The default
value is 4.
286