Urpf Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Multicast Group Enter the multicast IP address.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove a specific entry listed.
Click the Find button to find the information entered.
Click the View All button to view all the entries.

URPF Settings

This window is used to configure the Unicast Reverse Path Forwarding (URPF) settings. This will add URPF
checking on one or more ports. URPF helps to mitigate problems caused by the introduction of malformed or
forged IP source addresses into a network by discarding IP packets that lack a verifiable IP source address.
To view the following window, click L3 Features > URPF Settings, as shown below:
The fields that can be configured are described below:
Parameter Description
URPF Global
Select to enable or disable the URPF feature.
State
Unit Select the switch unit to configure.
From Port ~ To Select the range of port that will be used for this configuration.
Port
Figure 6-194 URPF Settings window
339