D-Link xStack DGS-3620 Series Reference Manual page 207

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IP Address
Netmask
IP Tunnel Name
Gateway
Metric (1-65535)
Backup State
Null Interface
Click the Apply button to accept the changes made.
Figure 6-1 IPv4 Static/Default Route Settings window (EI Mode Only)
Figure 6-2 IPv4 Static/Default Route Settings window (SI Mode Only)
Description
This field allows the entry of an IPv4 address to be assigned to the Static route. Tick the
Default check box to be assigned to the default route.
This field allows the entry of a subnet mask to be applied to the corresponding subnet
mask of the IP address.
Tick the IP Tunnel check box and enter the IP tunnel name used. (EI Mode Only)
This field allows the entry of a Gateway IP Address to be applied to the corresponding
gateway of the IP address.
Represents the metric value of the IP interface entered into the table. This field may read
a number between 1 and 65535.
Each IP address can only have one primary route, while another route should be
assigned to the backup state. When the primary route fails, the Switch will try the backup
route. The field represents the Backup state that the Static and Default Route is
configured for.
Use the drop-down menu to enable or disable the null interface as the next hop.
206