®
xStack
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
•
F15: Port number. The incoming port number of the DHCP client packet. An ASCII format string.
•
F16: Colon (:)
•
F17: cvlan is the client's VLAN ID. The value ranges from 1 to 4094. An ASCII format string.
•
F18: dot (.)
•
F19: ASCII format string "0".
•
F20: Space
•
F21: System name of the Switch. Note: If the system name exceeds 128 bytes, it will only use the first 128
bytes.
•
F22: Slash (/)
•
F23: ASCII format string "0".
•
F24: Slash (/)
•
F25: ASCII format string "0".
•
F26: Slash (/)
•
F27: Chassis ID like F11.
•
F28: Slash (/)
•
F29: ASCII format string "0".
•
F30: Slash (/)
•
F31: Port number. The incoming port number of the DHCP client packet. An ASCII format string.
DHCP Relay Interface Settings
Users can set up a server, by IP address, for relaying DHCP information to the Switch. The user may enter a
previously configured IP interface on the Switch that will be connected directly to the DHCP client using this
window. Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom of the
window, once the user clicks the Apply button. The user may add up to four server IPs per IP interface on the
Switch. Entries may be deleted by clicking the corresponding Delete button.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Interface Settings as
shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Server IP Address
Click the Apply button to accept the changes made.
DHCP Relay Option 60 Server Settings
On this page the user can configure the DHCP relay option 60 server parameters.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server
Figure 10-8 DHCP Relay Interface Settings window
Description
The IP interface on the Switch that will be connected directly to the client.
Enter the IP address of the DHCP server. Up to four server IPs can be configured per
IP Interface.
508