D-Link xStack DGS-3620 Series Reference Manual page 538

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
After clicking the Edit button, the following window appears:
The fields that can be configured are described below:
Parameter
MIP
SenderID
CCM
MEP ID(s)
Figure 11-3 CFM MA Settings (Edit) window
Description
This is the control creation of MIPs.
None - Don't create MIPs.
Auto - MIPs can always be created on any ports in this MA, if that port is not configured
with an MEP of that MA.
Explicit - MIP can be created on any ports in this MA, only if the next existent lower
level has an MEP configured on that port, and that port is not configured with an MEP
of this MA.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
This is the control transmission of the sender ID TLV.
None - Don't transmit sender ID TLV.
Chassis - Transmit sender ID TLV with chassis ID information.
Manage - Transmit sender ID TLV with manage address information.
Chassis Manage - Transmit sender ID TLV with chassis ID information and manage
address information.
Defer - Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
Select the CCM interval value here.
3.3ms – Specifies the CCM interval value as 3.3 milliseconds. Only work in the CFM
hardware mode.
10ms - Specifies the CCM interval value as 10 milliseconds. Only work in the CFM
hardware mode.
100ms - Specifies the CCM interval value as 100 milliseconds. Not recommended. For
test purpose.
1sec - Specifies the CCM interval value as 1 second.
10sec - Specifies the CCM interval value as 10 seconds. This is the default value.
1min - Specifies the CCM interval value as 1 minute.
10min - Specifies the CCM interval value as 10 minutes.
This is to specify the MEP IDs contained in the maintenance association. The range of
the MEP ID is 1-8191.
Add - Add MEP ID(s).
Delete - Delete MEP ID(s).
537