D-Link xStack DGS-3620 Series Reference Manual page 619

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Log Message: WAC authenticated user (Username: <string>, IP: <ipaddr | ipv6address>,
MAC: <macaddr>, Port: <[unitID:] portNum>)
Parameters description:
string: User name
ipaddr: IP address
ipv6address: IPv6 address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
JWAC Event description: When a client host authenticated successful.
Log Message: JWAC authenticated user (Username: <string>, IP: <ipaddr>, MAC:
<macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: Username
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: When a client host fails to authenticate.
Log Message: JWAC unauthenticated user (User Name: <string>, IP: <ipaddr>, MAC:
<macaddr>, Port: <[unitID:]portNum>)
Parameters description:
string: User name
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: This log will be triggered when the number of authorized users reaches the
maximum user limit on the whole device.
Log Message: JWAC enters stop learning state.
Event description: This log will be triggered when the number of authorized users is below the
maximum user limit on the whole device in a time interval (5 min).
Log Message: JWAC recovered from stop learning state.
LBD Event Description: Loop back is detected under port-based mode.
Log Message:
Port < [unitID:] portNum> LBD loop occurred. Port blocked.
Parameters Description:
portNum: The port number.
Event Description: Port recovered from LBD blocked state under port-based mode.
Log Message:
Port < [unitID:] portNum>LBD port recovered. Loop detection restarted
Parameters Description:
portNum: The port number.
Event Description: Loop back is detected under VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD loop occurred. Packet discard begun
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Event Description: Port recovered from LBD blocked state under VLAN-based mode.
Log Message:
Port < [unitID:] portNum> VID <vlanID> LBD recovered. Loop detection restarted
Parameters Description:
portNum: The port number.
vlanID: the VLAN ID number.
Event Description: The number of VLAN in which loop back occurs hit the specified number.
Log Message:
Loop VLAN number overflow.
Parameters Description:
None
IMPB Event description: Dynamic IMPB entry conflicts with static ARP.
Log Message: Dynamic IMPB entry conflicts with static ARP(IP: <ipaddr>, MAC: <macaddr>,
Port <[unitID:]portNum>)
Parameters description:
ipaddr: IP address
macaddr: MAC address
unitID: The unit ID
portNum : The port number
Event description: Dynamic IMPB entry conflicts with static FDB.
Log Message: Dynamic IMPB entry conflicts with static FDB(IP: [<ipaddr> | <ipv6addr>],
618
Informational
Warning
Warning
Warning
Critical
Informational
Critical
Informational
Informational
Warning
Warning