Session Table; Single Ip Management - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IP Address
Subnet Mask
Gateway
Status
Click the Apply button to accept the changes made.

Session Table

Users can display the management sessions since the Switch was last rebooted.
To view the following window, click Management > Session Table, as shown below:
Click the Refresh button to refresh the display table so that new entries will appear.

Single IP Management

Simply put, D-Link Single IP Management is a concept that will stack switches together over Ethernet instead of
using stacking ports or modules. There are some advantages in implementing the "Single IP Management" feature:
•
SIM can simplify management of small workgroups or wiring closets while scaling the network to handle
increased bandwidth demand.
•
SIM can reduce the number of IP address needed in your network.
•
SIM can eliminate any specialized cables for stacking connectivity and remove the distance barriers that
typically limit your topology options when using other stacking technology.
Switches using D-Link Single IP Management (labeled here as SIM) must conform to the following rules:
1. SIM is an optional feature on the Switch and can easily be enabled or disabled through the Command Line
Interface or Web Interface. SIM grouping has no effect on the normal operation of the Switch in the user's
network.
2. There are three classifications for switches using SIM. The Commander Switch (CS), which is the master
switch of the group, Member Switch (MS), which is a switch that is recognized by the CS a member of a
SIM group, and a Candidate Switch (CaS), which is a Switch that has a physical link to the SIM group but
has not been recognized by the CS as a member of the SIM group.
3. A SIM group can only have one Commander Switch (CS).
4. A SIM group accepts up to 32 switches (numbered 1-32), not including the Commander Switch (numbered
0).
5. Members of a SIM group cannot cross a router.
6. There is no limit to the number of SIM groups in the same IP subnet (broadcast domain); however a single
switch can only belong to one group.
7. If multiple VLANs are configured, the SIM group will only utilize the default VLAN on any switch.
Description
Enter the IP address of the interface.
Enter the subnet mask of the IP address.
Enter the gateway IP address of the out-of-band management network.
Use the drop-down menu to enable or disable the interface status.
Figure 4-18 Session Table window
67