Mld Snooping Rate Limit Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
Version
Topology Change
Notification
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the Modify Router Port
The fields that can be configured are described below:
Parameter
Unit
Static Router Port
Forbidden Router Port
Dynamic Router Port
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.

MLD Snooping Rate Limit Settings

Users can configure the rate limit of the MLD control packet that the switch can process on a specific port or VLAN
Specify the version of MLD packet that will be sent by this port. If a MLD packet
received by the interface has a version higher than the specified version, this packet
will be forwarded from the router ports or VLAN flooding.
Specifies that MLD snooping should be aware of link-layer topology changes
caused by the Spanning Tree operation or not. Selecting Ignore specifies that MLD
snooping will ignore link-layer topology changes caused by the Spanning Tree
operation. The General Query won't be sent on the same domain of link-layer
topology changes. Selecting Process specifies that MLD snooping will process link-
layer topology changes caused by the Spanning Tree operation. The General Query
will be sent on the same domain of link layer topology changes.
link, the following page will appear:
Figure 5-79 MLD Snooping Router Port Settings window
Description
Select the unit you want to configure.
This section is used to designate a range of ports as being connected to multicast-
enabled routers. This will ensure that all packets with such a router as its destination
will reach the multicast-enabled router regardless of the protocol.
This section is used to designate a range of ports as being not connected to
multicast-enabled routers. This ensures that the forbidden router port will not
propagate routing packets out.
Displays router ports that have been dynamically configured.
159