Bgp Trap Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Mode
Regular Expression
Regular Option
Community Set
(1-65535)
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
Click the Delete button to remove the specific entry.

BGP Trap Settings

This window is used to configure the BGP trap state.
To view the following window, click L3 Features > BGP > BGP Trap Settings, as shown below:
Figure 6-165 BGP Community Rule Settings - View Detail window
Description
Use the drop-down menu to permit or deny the routes if rule is matched.
Enter the community set value. This value can be up to 80 characters long.
Tick the check boxes to select the regular options.
Internet - Routes with this community will be sent to all peers either internal or external.
Local AS - Routes with this community will be sent to peers in the same AS, but will not
be sent to peers in another sub AS in the same confederation and to the external peers.
No Advertise - Routes with this community will not be advertised to any peer either
internal or external.
No Export - Routes with this community will be sent to peers in the same AS or in other
sub Autonomous Systems within a confederation, but will not be sent to an external BGP
(eBGP) peer.
A community is 4 bytes long, including the 2 bytes's for the Autonomous System's
number and 2 bytes for the network number This value is configured with two 2-byte
numbers separated by a colon. The valid range of both number are from 1 to 65535. A
community set can be formed by multiple communities, separated by a comma.
Figure 6-166 BGP Trap Settings window
320