Igmp Snooping Rate Limit Settings; Igmp Snooping Static Group Settings - D-Link DGS-3000 series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch Web UI Reference Guide
Dynamic Router Port
Ports
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.

IGMP Snooping Rate Limit Settings

On this page the user can configure the IGMP snooping rate limit parameters.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Rate Limit Settings, as show below:
The fields that can be configured are described below:
Parameter
Port List
VID List
Rate Limit (1-1000)
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IGMP Snooping Static Group Settings

Users can view the Switch's IGMP Snooping Group Table. IGMP Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Static Group Settings, as show below:
propagate routing packets out.
Displays router ports that have been dynamically configured.
Select the appropriate ports individually to include them in the Router Port
configuration.
Figure 4-46 IGMP Snooping Rate Limit Settings window
Description
Click the radio button and enter the port list used for this configuration.
Click the radio button and enter the VID list used for this configuration.
Enter the IGMP snooping rate limit used. Tick the No Limit check box to ignore the rate
limit.
95