Detect Cycle: The UCM6100 will check the system reboot based on this cycle. Users can enter
•
the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
4. System Crash
Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can
•
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
Click on the switch
could also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email
Notification On", "Email Notification Off" to control the alert and Email notification configuration.
ALERT
L OG
Under Web GUI->Status->System Events->Alert Log, system messages from triggered system events
are listed as alert logs. The following screenshot shows system crash alert logs.
Firmware Version 1.0.9.26
Figure 163: System Events->Alert Events Lists: System Reboot
Figure 164: System Events->Alert Events Lists: System Crash
to turn on/off the alert and Email notification for the event. Users
UCM6100 Series IP PBX User Manual
Page 278 of 304