Debug Vrrp Ipv6 - Dell Z9500 Command Reference Manual

Version
8.3.19.0
8.3.10.0
8.4.1.0
8.3.2.0

debug vrrp ipv6

Allows you to enable debugging of VRRP.
Z9500
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
Parameters
interface
vrid
all
bfd
database
packets
state
timer
Virtual Router Redundancy Protocol (VRRP)
Description
Introduced on the S4820T.
Introduced on the S4810.
Introduced on E-Series ExaScale, C-Series, and S-Series.
Support was added for IPv6 VRRP groups in non-default
VRF instances.
Introduced on the E-Series TeraScale.
Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
(OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
Enter the keyword all to enable debugging of all VRRP
groups.
Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
Enter the keyword database to display changes related to
group, prefix, and interface entries in the VRRP table.
Enter the keyword packets to enable debugging of VRRP
control packets.
Enter the keyword state to enable debugging of VRRP state
changes
Enter the keyword timer to enable debugging of the VRRP
timer.
1901