Dell Z9500 Command Reference Manual page 1903

•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.10.0
8.3.2.0
Usage The following describes the show vrrp ipv6 command shown in the following
Information
example.
Line Beginning
with
GigabitEthernet...
VRF
State: master...
Hold Down:...
Adv rcvd:...
Virtual Router Redundancy Protocol (VRRP)
EXEC Privilege
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series TeraScale.
Description
Displays the Interface, the VRRP group ID, and the network
address. If the interface is no sending VRRP packets, 0.0.0.0
appears as the network address.
VRF instance to which the interface (on which the VRRP
group is configured) belongs.
Displays the interface's state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface's priority and the IP address of the MASTER.
This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in
seconds.
• Preempt displays TRUE if preempt is configured and
FALSE if preempt is not configured.
• AdvInt displays the Advertise Interval in seconds.
This line displays counters for the following:
• Adv rcvd displays the number of VRRP advertisements
received on the interface.
• Adv sent displays the number of VRRP advertisements
sent on the interface.
1903