Installation Of Mguard Pci² Sd - Innominate mGuard Reference Manual

mGuard pci² SD
SD card slot (configuration
memory)
Reset button
94
Innominate Security Technologies
5.3 Installation of mGuard pci² SD
WARNING: This is a Class A item of equipment. This equipment can cause radio interfer-
ence in residential areas; in this case, the operator may be required to implement appro-
priate measures.
WARNING: Safe isolation of live circuits is only guaranteed if connected devices fulfill re-
quirements specified by VDE 0106-101 (safe isolation). The supply lines must be isolated
or laid separately to live circuits.
5.3.1 Installing the hardware
NOTE: Electrostatic discharge
Before installation, touch the metal frame of the PC in which the mGuard pci² SD is to be
installed, in order to remove electrostatic discharge.
The device contains components that can be damaged or destroyed by electrostatic dis-
charge. When handling the device, observe the necessary safety precautions against
electrostatic discharge (ESD) according to EN 61340-5-1 and IEC 61340-5-1.
mGuard pci² SD: structure
Extension connection (LEDs, Reset button, SD card)
Figure 5-3 mGuard pci² SD structure
• Install the mGuard pci² SD in a free PCI or PCI Express slot. Observe the notes in the
documentation for your system.
Battery (can be replaced)
RJ45 socket (LAN 1) for connecting to the in-
ternal network
Use a UTP cable (CAT5). The cable is not
supplied as standard.
RJ45 socket (WAN 1) for connecting to the
external network/Internet.
Use a UTP cable (CAT5). The cable is not
supplied as standard.
I15007_en_02