Mounting
Removal
I15007_en_02
1.3
Installation of mGuard rs4000/rs2000
1.3.1
Mounting/removal
The device is ready to operate when it is supplied. The recommended sequence for mount-
ing and connection is as follows:
•
Mount the mGuard rs4000/rs2000 on a grounded 35 mm DIN rail according to
DIN EN 60715.
Figure 1-3
Mounting the mGuard rs4000/rs2000 on a DIN rail
•
Attach the top snap-on foot of the mGuard rs4000/rs2000 to the DIN rail and then press
the mGuard rs4000/rs2000 down towards the DIN rail until it engages with a click.
•
Remove or disconnect the connections.
•
To remove the mGuard rs4000/rs2000 from the DIN rail, insert a screwdriver horizon-
tally in the locking slide under the housing, pull it down – without tilting the screwdriver
– and then pull up the mGuard rs4000/rs2000.
mGuard rs4000/rs2000
Innominate Security Technologies
15