Table of Contents
Advertisement
I15007_en_02
8.4
Preparing the configuration
8.4.1
Connection requirements
mGuard delta
–
The mGuard delta must be connected to its power supply.
–
For local configuration: The computer used for configuration:
–
Must be connected to the LAN switch (Ethernet socket 4 to 7) of the mGuard,
–
Or must be connected to the mGuard via the local network.
–
For remote configuration: The mGuard must be configured so that remote configura-
tion is permitted.
–
The mGuard must be connected, i.e., the required connections must be working.
8.4.2
Local configuration on startup (EIS)
As of firmware version 7.2, initial startup of mGuard products provided in Stealth mode is
considerably easier. From this version onwards, the EIS (Easy Initial Setup) procedure en-
ables startup to be performed via preset or user-defined management addresses without
actually having to connect to an external network.
The mGuard is configured using a web browser on the computer used for configuration.
NOTE: The web browser used must support SSL encryption (i.e., HTTPS).
According to the default setting, the mGuard can be accessed via the following addresses:
Table 8-3
Preset addresses
Default setting
mGuard delta
Network
Management IP #1
mode
Router
–
mGuard delta
Management IP #2
https://192.168.1.1/
Innominate Security Technologies
147
Advertisement
Table of Contents
