Restart, Recovery Procedure, And Flashing The Firmware - Innominate mGuard Reference Manual

EAGLE mGuard
Power supply 1 (P1)
Power supply 2 (P2)
Link status/data 1 (LAN)
Link status/data 2 (WAN)
Objective
Action
250
Innominate Security Technologies
13.8 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Reset button
USB
Serial V.24
Figure 13-7 Reset button
13.8.1 Performing a restart
The device is restarted with the configured settings.
• Press the Reset button for around 1.5 seconds until the middle LED lights up in red.
(Alternatively, disconnect the power supply and then connect it again.)
FAULT
STATUS
Serial V.24
Ethernet LAN
Ethernet WAN
Ground connection
I15007_en_02