Table of Contents
Advertisement
I15007_en_02
4.4
Preparing the configuration
4.4.1
Connection requirements
mGuard delta²
–
The mGuard delta² must be connected to its power supply.
–
For local configuration: The computer that is to be used for configuration must be
connected to the LAN socket on the mGuard.
–
For remote configuration: The mGuard must be configured so that remote configura-
tion is permitted.
–
The mGuard must be connected, i.e., the required connections must be working.
4.4.2
Local configuration on startup (EIS)
As of firmware version 7.2, initial startup of mGuard products provided in Stealth mode is
considerably easier. From this version onwards, the EIS (Easy Initial Setup) procedure en-
ables startup to be performed via preset or user-defined management addresses without
actually having to connect to an external network.
The mGuard is configured using a web browser on the computer used for configuration.
NOTE: The web browser used must support SSL encryption (i.e., HTTPS).
According to the default setting, the mGuard can be accessed via the following addresses:
Table 4-3
Preset addresses
Default setting
mGuard delta²
The mGuard is preset to the "multiple Clients" stealth configuration. You need to configure
a management IP address and default gateway if you want to use VPN connections (in the
web interface under "Network >> Interfaces >> General"). Alternatively, you can select a dif-
ferent stealth configuration or use another network mode.
Network
Management IP #1
mode
Stealth
https://1.1.1.1/
mGuard delta²
Management IP #2
https://192.168.1.1/
Innominate Security Technologies
79
Advertisement
Table of Contents
