Table of Contents
Advertisement
Boot options
I15007_en_02
If the boot menu is to be displayed, press one of the direction keys several times:
or
.
Figure 7-4
mGuard centerport² boot menu
To select and apply one of the boot options, proceed as follows:
1.
Select one of the displayed options with the direction keys
2.
Then press the Enter button.
Boot rootfs1
Start the primary firmware version on the device (A). This is the default setting: it is ap-
plied if the user does not intervene during startup.
Boot rootfs2
Not supported by the current firmware version.
Check the file system(s) of firmware on rootfs1
If required, checks and repairs all firmware file systems.
This menu item is only to be used in special cases when the user has the appropriate
knowledge or upon instruction from the dealer support team. The mGuard firmware
checks and repairs the file systems, if required, even during the normal startup process.
The firmware uses its file systems in a highly robust manner when the mass storage de-
vice cache is switched off, so that there is not usually any need for repairs.
Check the file system(s) of firmware on rootfs2
Not supported by the current firmware version.
Start rescue procedure via DHCP/BootP+TFTP
Start rescue procedure from CD / DVD, USB stick or SD Card
"Restart, recovery procedure, and flashing the firmware" on page 136
mGuard centerport²
or
.
Innominate Security Technologies
,
,
131
Advertisement
Table of Contents
