Innominate mGuard Reference Manual page 56

mGuard rs4000/rs2000 3G
56
Innominate Security Technologies
3.3.2 Connecting to the network
NOTE: Risk of material damage due to incorrect wiring
Only connect the mGuard network ports to LAN installations. Some telecommunications
connections also use RJ45 sockets; these must not be connected to the RJ45 sockets of
the mGuard.
• Connect the mGuard to the network. To do this, you need a suitable UTP cable (CAT5)
which is not included in the scope of supply. Use UTP cables with an impedance of
100 Ω.
• Connect the internal network interface LAN of the mGuard to the corresponding Ether-
net network card of the configuration computer or a valid network connection of the in-
ternal network (LAN).
I15007_en_02