Technical Data - Innominate mGuard Reference Manual

Hardware properties
Platform
Network interfaces
Other interfaces
Drives
Redundancy options
Power supply
Power consumption
Humidity range
Degree of protection
Temperature range
Dimensions (H x W x D)
Weight
Firmware and power values
Firmware compatibility
Data throughput (router | firewall)
Hardware-based encryption
Encrypted VPN throughput (AES-256)
Management support
Diagnostics
Other
Conformance
I15007_en_02
9.9

Technical data

mGuard pci /266 | mGuard pci /533
Intel network processor
Optionally with 266 MHz or 533 MHz clocking
1 LAN port | 1 WAN port
Ethernet IEEE 802.3 10/100 Base TX |
RJ45 | full duplex | auto MDIX
Serial RS-232, internal connector
–
Depending on the firmware used
3.3 V or 5 V, via PCI bus
Typical, 3.7 W ... 4.2 W
20% ... 90% during operation, non-condensing
Depending on installation type
0°C ... +70°C (operation)
-20°C ... +70°C (storage)
Low profile PCI
72 g
mGuard v5.0 or later: Innominate recommends firmware version 6.x or 7.x to
be used with the latest patch releases;
For the scope of functions, please refer to the relevant firmware data sheet.
99 Mbps bidirectional | 99 Mbps bidirectional
DES | 3DES | AES-128/192/256
35 Mbps (PCI /256) bidirectional | 70 Mbps (PCI /533) bidirectional
Web GUI (HTTPS) | command line interface (SSH) | SNMP v1/2/3 | central
device management software
LEDs (2 x LAN, 2 x WAN in combination for boot process, system error, Ether-
net status, Recovery mode) | Log File | Remote Syslog
CE | FCC | UL 508 | Operating modes with/without driver via PoPCI
mGuard pci
Innominate Security Technologies
179