Restart, Recovery Procedure, And Flashing The Firmware - Innominate mGuard Reference Manual

mGuard rs4000/rs2000 Switch
Objective
Action
46
Innominate Security Technologies
2.8 Restart, recovery procedure, and flashing the firm-
ware
The reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Reset button
Figure 2-6 Reset button
2.8.1 Performing a restart
The device is restarted with the configured settings.
• Press the reset button for around 1.5 seconds until the Err LED lights up.
(Alternatively, disconnect the power supply and then connect it again.)
I15007_en_02