Table of Contents
Advertisement
mGuard pci
Objective
Action
176
Innominate Security Technologies
9.8.2
Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the mGuard.
When performing the recovery procedure, the default settings are established:
Table 9-5
Preset addresses
Default setting
mGuard pci
The mGuard is reset to Stealth mode with the default setting "multiple Clients".
–
The CIFS integrity monitoring function is also disabled because this only works when
the management IP is active.
–
In addition, MAU management is switched on for Ethernet connections. HTTPS access
is enabled via the local Ethernet connection (LAN).
–
The settings configured for VPN connections and the firewall are retained, including
passwords.
Possible reasons for performing the recovery procedure:
–
The mGuard is in Router or PPPoE mode.
–
The configured device address of the mGuard differs from the default setting.
–
The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your mGuard firmware version.
You can find application notes under the following Internet address:
www.innominate.com.
•
Slowly press the Reset button six times.
After approximately 2 seconds, the LAN LED lights up red.
•
Press the Reset button slowly again six times.
If successful, the LAN LED lights up red.
If unsuccessful, the WAN LED lights up red.
If successful, the device restarts after two seconds and switches to Stealth mode. The de-
vice can then be reached again under the corresponding addresses.
Network
Management IP #1
mode
Stealth
https://1.1.1.1/
Management IP #2
https://192.168.1.1/
I15007_en_02
Advertisement
Table of Contents
