mGuard rs4000/rs2000 3G
Objective
Action
68
Innominate Security Technologies
3.8
Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
–
Performing a restart
–
Performing a recovery procedure
–
Flashing the firmware/rescue procedure
Reset button
Figure 3-9
Reset button
3.8.1
Performing a restart
The device is restarted with the configured settings.
•
Press the Reset button for around 1.5 seconds until the Err LED lights up.
(Alternatively, disconnect the power supply and then connect it again.)
I15007_en_02