Table of Contents
Advertisement
mGuard blade
188
Innominate Security Technologies
10.4.3
Configuring the mGuard with the Router mode default set-
ting
By default upon delivery, following a reset to the default setting or after flashing the
mGuard, the device can be accessed within network 192.168.1.0/24 via the LAN interface
(for mGuard blade LAN interfaces 4 to 7) under IP address 192.168.1.1.
To access the configuration interface, it may be necessary to adapt the network configura-
tion of your computer.
Under Windows 7, proceed as follows:
•
In the Control Panel, open the "Network and Sharing Center".
•
Click on "LAN connection". (The "LAN connection" item is only displayed if a connection
exists from the LAN interface on the computer to a mGuard in operation or another part-
ner).
•
Click on "Properties".
•
Select the menu item "Internet protocol Version 4 (TCP/IPv4)".
•
Click on "Properties".
•
First select "Use the following IP address" under "Internet Protocol Version 4 Proper-
ties", then enter the following address, for example:
IP address:
Subnet mask:
Default gateway:
Depending on the configuration of the mGuard, it may then be necessary to adapt the net-
work interface of the locally connected computer or network accordingly.
192.168.1.2
255.255.255.0
192.168.1.1
I15007_en_02
Advertisement
Table of Contents
