Table of Contents
Advertisement
Objective
Action
I15007_en_02
3.8.2
Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the mGuard.
When performing the recovery procedure, the default settings are established:
Table 3-5
Preset address
Default setting
mGuard rs4000 3G
mGuard rs2000 3G
The mGuard is reset to router mode with the fixed IP address.
–
The CIFS integrity monitoring function is also disabled because this only works when
the management IP is active.
–
In addition, MAU management is switched on for Ethernet connections. HTTPS access
is enabled via the local Ethernet connection (LAN).
–
The settings configured for VPN connections and the firewall are retained, including
passwords.
Possible reasons for performing the recovery procedure:
–
The mGuard is in Router or PPPoE mode.
–
The configured device address of the mGuard differs from the default setting.
–
The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your mGuard firmware version.
You can find application notes under the following Internet address:
www.innominate.com.
•
Slowly press the Reset button six times.
After approximately two seconds, the Stat LED lights up green.
•
When the Stat LED has gone out, slowly press the Reset button again six times.
If successful, the Stat LED lights up green.
If unsuccessful, the Err LED lights up red.
If successful, the device restarts after two seconds and switches to Router mode. The de-
vice can then be reached again under the corresponding address.
Network mode
Management IP #1
Router
https://192.168.1.1/
Router
https://192.168.1.1/
Innominate Security Technologies
mGuard rs4000/rs2000 3G
69
Advertisement
Table of Contents
