Operating Elements And Leds - Innominate mGuard Reference Manual

mGuard rs4000/rs2000 Switch
Reset button
LEDs, see Table 2-2
LAN port (protected)
LAN port (protected)
LAN port (protected)
LAN port (protected)
Slot for optional SD card
Table 2-2 LEDs on the mGuard rs4000 Switch and mGuard rs2000 Switch
LED State
P1 Green
P2 Green
Stat Green
Err Red
Stat + Err Flashing alternately:
green and red
Mod Green
Fault Red
34
Innominate Security Technologies
2.1

Operating elements and LEDs

DMZ port
WAN port
Figure 2-2 Operating elements and LEDs on the mGuard rs4000 Switch
Meaning
On Power supply 1 is active
On Power supply 2 is active (mGuard rs2000 Switch: not used)
Flashing Heartbeat. The device is correctly connected and operating.
Flashing System error. Restart the device.
– Press the reset button shortly (for 1.5 seconds).
– Alternatively, briefly disconnect the device power supply and then connect it
again.
If the error is still present, start the recovery procedure (see page 47) or contact
your dealer.
Boot process. When the device has been connected to the power supply. After a
few seconds, this LED changes to the heartbeat state.
On Connection via modem established
On The signal output takes low level due to an error (inverted logic). The signal output
is inactive during a restart.
Plug-in screw terminal
blocks, for assignment, refer
to page 39 and page 41
RS-232 interface
(bottom)
I15007_en_02