Innominate mGuard Reference Manual page 164

mGuard pci
164
Innominate Security Technologies
9.3.3 Installing the hardware
NOTE: Electrostatic discharge
Before installation, touch the metal frame of the PC in which the mGuard pci is to be in-
stalled, in order to remove electrostatic discharge.
The device contains components that can be damaged or destroyed by electrostatic dis-
charge. When handling the device, observe the necessary safety precautions against
electrostatic discharge (ESD) according to EN 61340-5-1 and IEC 61340-5-1.
mGuard pci: structure
How to proceed
• Configure the mGuard pci for Driver mode or Power-over-PCI mode. (see "Selection of
Driver mode or Power-over-PCI mode" on page 160)
• To do this, set the jumper (2) to the relevant position:
Driver mode
3
2
1
Figure 9-7 Jumper for Driver mode or Power-over-PCI mode
• Switch off the computer and any other connected I/O devices.
• Observe the safety notes for electrostatic discharge.
• Unplug the power cable.
(1) Reset button
(2) Jumper for activating/deactivating Driver
mode
(3) LAN port
The LAN port is deactivated in Driver mode. In
Power-over-PCI mode, the network card of the
same or another computer to be protected or of
the network to be protected is connected here.
(4) WAN port
Connections to the external network (e.g., In-
ternet) are established via this interface. With
the default firewall settings, incoming connec-
tions are blocked here. Use a UTP cable
(CAT5).
Power-over-PCI mode
3
2
1
I15007_en_02