Innominate mGuard Reference Manual page 212

mGuard centerport
212
Innominate Security Technologies
3. Then select one of the options to perform the rescue procedure with the arrow keys
or :
Start rescue procedure via DHCP/BootP+TFTP
OR
Start rescue procedure from CD/DVD
OR
Start rescue procedure from USB mass storage
To apply the selection, press the Enter key.
The options include:
Start rescue procedure via DHCP/BootP+TFTP
Effect: The mGuard downloads all necessary files from the TFTP server. The names of
the downloaded files correspond to those used from the other models of the mGuard
family, with the following exceptions:
– install.p7s -> install.x86_64.p7s
– jffs2.img.p7s -> firmware.img.x86_64.p7s
In the case of the file install.x86_64.p7s, ensure that the file version that Innominate has
declared for use for the rescue procedure via TFTP is used.
Start rescue procedure from CD/DVDs
Requirement: The firmware of the mGuard has been previously burnt to CD - see
below under "Burning mGuard firmware to CD-ROM" on page 212.
Effect: The mGuard downloads all necessary files from the inserted CD.
With this in mind, while the boot menu is displayed and before applying this selection,
insert the CD with the mGuard firmware into the CD drive.
(For security reasons, the mGuard centerport does not boot from the CD).
Start rescue procedure from USB mass storage
Requirement: The firmware of the mGuard has been previously copied to a USB stor-
age medium (USB stick).
As the first primary partition, the USB storage medium must have a VFAT file system
and must contain the same files in the same folders, as stored on the CD. In addition to
this, as is the case for a CD, the specified files can be located in the Rescue Config
folder.
Effect: The mGuard downloads all necessary files from the connected USB storage
medium. With this in mind, while the boot menu is displayed and before applying this
selection at the very latest, connect the USB storage medium containing the firmware
to the USB interface. (For security reasons, the mGuard centerport does not boot from
the USB storage medium).
4. Once the rescue procedure is complete, a corresponding message appears on the
monitor. Follow any further on-screen instructions.
The mGuard is in the delivery state. You can now configure it again (see "Establishing a
local configuration connection" on page 206):
Burning mGuard firmware to CD-ROM
The firmware for the mGuard can be burnt to CD. A zip file is available for download from
the download page of www.innominate.com.
The content of this zip archive can be burnt as a data CD. The following files must be located
in the following folders/under the following path names on the CD:
– Firmware/install.x86_64.p7s
I15007_en_02