Innominate mGuard Reference Manual page 53

Table 3-2 LEDs on the mGuard rs4000 3G and mGuard rs2000 3G [...]
LED State
Info2 Green
Info1 Green
*
WAN 1 Green
DMZ* Green
LAN 1–4 Green
Bar graph LED 3
LED 2
LED 1
Signal strength
Network reception
SIM 1 Green
SIM 2 Green
*
only mGuard rs4000 3G
I15007_en_02
Meaning
On Up to firmware version 8.0
The configured VPN connection has
been established at output O1.
Flashing The configured VPN connection is
being established or aborted at output
O1.
On Up to firmware version 8.0
The configured VPN connection has
been established at output O2.
Flashing The configured VPN connection is
being established or aborted at output
O2.
On The LEDs are located in the sockets (10/100 and duplex LED)
On
Ethernet status. The LEDs indicate the status of the relevant port. As soon as the
device is connected to the relevant network, a continuous light indicates that there
On
is a connection to the network partner in the LAN, WAN or DMZ. When data pack-
ets are transmitted, the LED goes out briefly.
Top Off
Middle Off
Bottom Off
-113 ... 111 dBm
Very poor to none
On SIM card 1 active
Flashing No PIN or incorrect one entered
On SIM card 2 active
Flashing No PIN or incorrect one entered
As of firmware version 8.1
The configured VPN connections are
established at output O1 or the firewall
rule records defined at output O1 are
activated.
The configured VPN connections are
being established or aborted at output
O1 or the firewall rule records defined at
output O1 are activated or deactivated.
As of firmware version 8.1
The configured VPN connections are
established at output O2 or the firewall
rule records defined at output O2 are
activated.
The configured VPN connections are
being established or aborted at output
O2 or the firewall rule records defined at
output O2 are activated or deactivated.
Yellow Yellow
Off Green
Off Off
-109 ... 89 dBm -87 ... 67 dBm
Sufficient Good
mGuard rs4000/rs2000 3G
Yellow
Green
Green
-65 ... 51 dBm
Very good
Innominate Security Technologies
53