mGuard pci
Table 9-2
LEDs on the mGuard pci
LEDs
State
WAN, LAN
Red
WAN
Red
WAN, LAN
Green
WAN
Red/gree
n
LAN
Green
158
Innominate Security Technologies
9.1
Operating elements and LEDs
9.1.1
mGuard pci
Figure 9-2
Operating elements and LEDs on the mGuard pci
Meaning
Flashing
Boot process. When the computer is started or restarted.
Flashing
System error. Restart the device.
•
Press the Reset button (for 1.5 seconds).
•
Alternatively, briefly disconnect the device power supply and then connect it
again.
If the error is still present, start the recovery procedure (see "Performing a recov-
ery procedure" on page 176) or contact your dealer.
On or flash-
Ethernet status. Indicates the status of the LAN or WAN interface. As soon as
ing
the device is connected, a continuous light indicates that there is a connection to
the network partner.
When data packets are transmitted, the LED goes out briefly.
Various LED
Recovery mode. After pressing the Reset button*.
light codes
See "Restart, recovery procedure, and flashing the firmware" on page 175
* On the mGuard pci, the Reset button is on the PCB (see "Installing the hardware" on
page 164).
LAN green
LAN red
WAN green
WAN red
I15007_en_02