Installing And Booting Mguard Centerport - Innominate mGuard Reference Manual

mGuard centerport
Back
2 x power supply/mains input socket, redun-
dant wide-range AC power supply unit
(100 - 240 V AC voltage source)
200
Innominate Security Technologies
11.3

Installing and booting mGuard centerport

Unnamed connections/sockets are
not used.
Optional: Dedicated interface for state syn-
chronization in redundancy operation
Figure 11-4 mGuard centerport back
11.3.1 Connecting the device
7. Optional:
Install the device in a 19" industrial cabinet - see "The safety lock on the front flap en-
ables the front flap to be securely locked, so that access is refused to the drives, reset
button, and ON/OFF switch. Ensure that you keep safe hold of the two keys provided-
Housing" on page 202.
8. Connect the two power supply units to the mains or power supply source via the two
mains input sockets (100 - 240 V AC).
9. Connect the network connections - see "Connecting network connections" on
page 201.
10. Optional:
Connect a PC monitor to the VGA port (not supplied as standard).
Connect a PC keyboard to one of the USB connections (not supplied as standard).
The monitor and keyboard must only be connected
– in order to use one of the boot options upon starting (booting) mGuard centerport -
see "Boot options - when monitor and keyboard are connected" on page 202,
– in order to perform a rescue procedure or recovery procedure. See "Restart, recov-
ery procedure, and flashing the firmware" on page 209
The keyboard and monitor do not need to be connected to start and operate the device.
2 x USB
COM1:
Serial console/modem
VGA connection
Ethernet (10/100/1000 Base-TX)
WAN
LAN
2 x USB
I15007_en_02