Table of Contents
Advertisement
mGuard industrial rs
Lower terminal strip
220
Innominate Security Technologies
If your computer is already connected to a network, patch the mGuard between
the existing network connection.
Please note that configuration can only be completed via the LAN interface and that the
firewall of the mGuard industrial rs blocks all IP data traffic from the WAN to the LAN in-
terface.
WAN port
•
Use a UTP cable (CAT5).
•
Connect the external network via the WAN socket, e.g., WAN, Internet. (Connections
to the remote device/network are established via this network.)
Driver installation is not required.
For security reasons, we recommend you change the default root and administrator pass-
words during initial configuration.
Connection options on the lower terminal block
The mGuard industrial rs is available in three versions, which can be distinguished by the
connection options on the lower terminal strip:
With ISDN terminal
Figure 12-5
mGuard industrial rs: Lower terminal strip
With analog modem
WITHOUT modem/ISDN
I15007_en_02
Advertisement
Table of Contents
