Technical Data - Innominate mGuard Reference Manual

mGuard rs4000/rs2000 Switch
Hardware properties
Platform
Network interfaces
Other interfaces
Memory
Redundancy options
Power supply
Current consumption
Humidity range
Degree of protection
Temperature range
Dimensions (H x W x D)
Weight
Firmware and power values
Firmware compatibility
Data throughput (router | firewall)
Virtual Private Network (VPN)
Hardware-based encryption
Encrypted VPN throughput (AES-256)
Management support
Diagnostics
Other
Special features
50
Innominate Security Technologies
2.9

Technical data

mGuard rs4000 Switch
Freescale network processor
4 LAN ports (managed) | 1 DMZ port |
1 WAN port
Ethernet IEEE 802.3 10/100 Base TX
RJ45 | full duplex | auto MDIX
Serial RS-232 | D-SUB 9 connector
3 digital inputs and 3 digital outputs
128-Mbyte RAM | 128-Mbyte Flash
SD card
Replaceable configuration memory
Optional: VPN | router and firewall
Voltage range 11 ... 36 V DC, redundant
Typical < 200 mA (24 V DC) |
Maximum < 800 mA (10 V DC)
5% ... 95% (operation, storage), non-con-
densing
IP20
-20°C ... +60°C (operation)
-20°C ... +70°C (storage)
130 mm x 45 mm x 114 mm
(up to DIN rail support)
835 g
mGuard rs4000 Switch
Firmware 8.1.5: Innominate recommends the use of the latest firmware version and
patch releases in each case.
For the scope of functions, please refer to the relevant firmware data sheet.
Router mode, default firewall rules, bidirectional throughput: 99 Mbps, maximum
Stealth mode, default firewall rules, bidirectional throughput: 50 Mbps, maximum
When using the DMZ as independent network zone, the maximum possible data
throughput is distributed to the three zones.
IPsec (IETF standard)
Up to 250 VPN tunnels
DES | 3DES | AES-128/192/256
Router mode, default firewall rules, bidirectional throughput: 35 Mbps, maximum
Stealth mode, default firewall rules, bidirectional throughput: 25 Mbps, maximum
When using the DMZ as independent network zone, the maximum possible data
throughput is distributed to the three zones.
Web GUI (HTTPS) | command line interface (SSH) | SNMP v1/2/3 | central device man-
agement software
13 LEDs (Power 1 + 2, State, Error, Signal, Fault, Modem, Info, Signal Status, SIM Sta-
tus) | service I/O | log file | remote Syslog
mGuard rs4000 Switch
Realtime clock | Trusted Platform Module (TPM) | temperature sensor | mGuard Se-
cure Cloud ready
mGuard rs2000 Switch
Freescale network processor
5 LAN ports (unmanaged)
Ethernet IEEE 802.3 10/100-BaseTX
RJ45 | full duplex | auto MDIX
Serial RS-232 | D-SUB 9 connector
3 digital inputs and 3 digital outputs
128-Mbyte RAM | 128-Mbyte Flash
SD card
Replaceable configuration memory
–
Voltage range 11 ... 36 V DC
Typical < 200 mA (24 V DC) |
Maximum < 800 mA (10 V DC)
5% ... 95% (operation, storage), non-con-
densing
IP20
-20°C ... +60°C (operation)
-20°C ... +70°C (storage)
130 mm x 45 mm x 114 mm
(up to DIN rail support)
835 g
mGuard rs2000 Switch
IPsec (IETF standard)
Up to 2 VPN tunnels
DES | 3DES | AES-128/192/256
mGuard rs2000 Switch
I15007_en_02