Restart, Recovery Procedure, And Flashing The Firmware - Innominate mGuard Reference Manual

Objective
Action
I15007_en_02
9.8 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Reset button
Figure 9-13 Reset button
9.8.1 Performing a restart
The device is restarted with the configured settings.
• Press the Reset button for around 1.5 seconds until both red LEDs light up.
Alternatively, restart the computer that contains the mGuard pci card.
mGuard pci
Innominate Security Technologies
175