Table of Contents
Advertisement
Requirement
How to proceed
Example
Configuration
I15007_en_02
2.7
Remote configuration
The device must be configured so that remote configuration is permitted.
By default upon delivery, the option for remote configuration is disabled.
Switch on the remote configuration option in the web interface under "Management >> Web
Settings".
To configure the device via its web user interface from a remote computer, establish the
connection to the device from there.
Proceed as follows:
•
Start the web browser on the remote computer.
•
Under address, enter the IP address where the device can be accessed externally over
the Internet or WAN, together with the port number (if required).
If the device can be accessed over the Internet, for example, via address
https://123.45.67.89/ and port number 443 has been specified for remote access, the fol-
lowing address must be entered in the web browser of the remote peer:
https://123.45.67.89/
If a different port number is used, it should be entered after the IP address, e.g.,
https://123.45.67.89:442/
The device can then be configured via the web interface. For additional information, please
refer to software reference manual.
mGuard rs4000/rs2000 Switch
Innominate Security Technologies
45
Advertisement
Table of Contents
