Innominate mGuard Reference Manual page 242

EAGLE mGuard
242
Innominate Security Technologies
Mounting
The device is ready to operate when it is supplied. The recommended sequence for mount-
ing is as follows:
• Pull out the terminal block from the EAGLE mGuard and wire the supply voltage lines
and signal lines.
• Mount the EAGLE mGuard on a grounded 35 mm DIN rail according to EN 60715.
Figure 13-5 EAGLE mGuard: DIN rail mounting
• Attach the top snap-on foot of the EAGLE mGuard to the DIN rail and then press the
EAGLE mGuard down towards the DIN rail until it engages with a click.
• Connect the device to the local network or the local computer to be protected (LAN).
• Via the socket for connection to the external network, establish the connection to the
external network, e.g., Internet. Connections to the remote device or network are estab-
lished via this network.
• The front plate of the EAGLE mGuard housing is grounded via the ground connection.
Network connection
NOTE: If your computer is already connected to a network, patch the EAGLE mGuard be-
tween the existing network connection.
Please note that configuration can only be completed via the LAN interface and that the
firewall of the EAGLE mGuard blocks all IP data traffic from the WAN to the LAN interface.
Driver installation is not required.
For security reasons, we recommend you change the default root and administrator pass-
words during initial configuration.
Both network interfaces of the EAGLE mGuard are configured for connection on a comput-
er.
When connecting to a hub, please note the following:
When auto negotiation is deactivated, the Auto MDIX function is also deactivated. This
means that the port of the EAGLE mGuard must either be connected to the uplink port of
the hub or connected to the hub using a cross-link cable.
Removal
To remove the EAGLE mGuard from the DIN rail, insert a screwdriver horizontally in the
locking slide under the housing, pull it down – without tilting the screwdriver – and then pull
up the EAGLE mGuard.
I15007_en_02