Table of Contents
Advertisement
I15007_en_02
13.4
Preparing the configuration
13.4.1
Connection requirements
–
The EAGLE mGuard must be connected to at least one active power supply unit.
–
For local configuration: The computer used for configuration:
–
Must be connected to the LAN socket of the mGuard
–
Or the computer must be connected to the mGuard via the network.
–
For remote configuration: The mGuard must be configured so that remote configura-
tion is permitted.
–
The mGuard must be connected, i.e., the required connections must be working.
13.4.2
Local configuration on startup (EIS)
As of firmware version 7.2, initial startup of mGuard products provided in Stealth mode is
considerably easier. From this version onwards, the EIS (Easy Initial Setup) procedure en-
ables startup to be performed via preset or user-defined management addresses without
actually having to connect to an external network.
The mGuard is configured using a web browser on the computer used for configuration.
NOTE: The web browser used must support SSL encryption (i.e., HTTPS).
According to the default setting, the mGuard can be accessed via the following addresses:
Table 13-3
Preset addresses
Default setting
EAGLE mGuard
The mGuard is preset to the "multiple Clients" stealth configuration. You need to configure
a management IP address and default gateway if you want to use VPN connections (in the
web interface under "Network >> Interfaces >> General"). Alternatively, you can select a dif-
ferent stealth configuration or use another network mode.
Network
Management IP #1
mode
Stealth
https://1.1.1.1/
EAGLE mGuard
Management IP #2
https://192.168.1.1/
Innominate Security Technologies
243
Advertisement
Table of Contents
