Table of Contents
Advertisement
I15007_en_02
–
Firmware/firmware.img.x86_64.p7s
In the case of the file install.x86_64.p7s, ensure that the file version that Innominate has de-
clared for use for the rescue procedure via CD is used.
If required, these files can be made available in the Rescue Config folder on the CD:
Rescue Config/licence.lic
Rescue Config/<serial>.lic
Rescue Config/preconfig.atv Configuration profile, which should be applied in the firm-
Rescue Config/<serial>.atv
Rescue Config/preconfig.sh Script file, which is run directly after installation of the new
License file that should be installed in the device during the
rescue procedure.
As above, only the wildcard <serial> is replaced by the serial
number of the device. The same CD can be used for various
devices simultaneously.
ware during the rescue procedure. The file must be applied
by script Rescue Config/preconfig.sh.
Same as <serial>.lic
firmware. You can find details in the document "Innominate
mGuard - Application Note: Rollout Support" under
www.innominate.com.
mGuard centerport
Innominate Security Technologies
213
Advertisement
Table of Contents
