Innominate mGuard Reference Manual page 153

Objective
Action
I15007_en_02
8.7.2 Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the mGuard.
When performing the recovery procedure, the default settings are established:
Table 8-5 Preset addresses
Default setting
mGuard delta
The settings configured for VPN connections and the firewall are retained, including pass-
words.
Possible reasons for performing the recovery procedure:
– The mGuard is in PPPoE mode.
– The configured device address of the mGuard differs from the default setting.
– The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your mGuard firmware version.
You can find application notes under the following Internet address:
www.innominate.com.
• Slowly press the Reset button six times.
After approximately 2 seconds, the Status LED lights up green.
• Press the Reset button slowly again six times.
If successful, the Status LED lights up green.
If unsuccessful, the Status LED remains unlit.
If successful, the device restarts after two seconds and switches to Router mode. The de-
vice can then be reached again under the corresponding addresses.
Network Management IP #1
mode
Router –
mGuard delta
Management IP #2
https://192.168.1.1/
Innominate Security Technologies
153