Restart, Recovery Procedure, And Flashing The Firmware - Innominate mGuard Reference Manual

mGuard industrial rs
Reset button
Located in the opening. Can be
pressed with a straightened paper
clip, for example.
Objective
Action
232
Innominate Security Technologies
12.8 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Figure 12-11 Reset button
12.8.1 Performing a restart
The device is restarted with the configured settings.
• Press the Reset button for around 1.5 seconds until the middle LED lights up red.
(Alternatively, disconnect the power supply and then connect it again.)
I15007_en_02