Table of Contents
Advertisement
Hardware properties
Platform
Network interfaces
Other interfaces
Memory
Redundancy options
Power supply
Power consumption
Humidity range
Degree of protection
Temperature range
Dimensions (H x W x D)
Weight
Firmware and power values
Firmware compatibility
Data throughput (router | firewall)
Virtual Private Network (VPN)
Hardware-based encryption
Encrypted VPN throughput (AES-256)
Management support
Diagnostics
Other
Conformance
Special features
I15007_en_02
1.9
Technical data
mGuard rs4000
Freescale network processor with
330 MHz clocking
1 LAN port | 1 WAN port
Ethernet IEEE 802.3 10/100-BaseTX
RJ45 | full duplex | auto MDIX
Serial RS-232 | D-SUB 9 connector
2 digital inputs and 2 digital outputs
128 MB RAM | 128 MB Flash | SD card
Replaceable configuration memory
Optional: VPN | router and firewall
Voltage range 11 ... 36 V DC, redundant
2.13 W, typical
5% ... 95% (operation, storage), non-con-
densing
IP20
-20°C ... +60°C (operation)
-20°C ... +60°C (storage)
130 x 45 x 114 mm (up to DIN rail support)
725 g (TX/TX)
mGuard rs4000
For mGuard v7.4.0 or later: Innominate recommends the use of the latest firmware ver-
sion and patch releases in each case.
For the scope of functions, please refer to the relevant firmware data sheet.
Router mode, default firewall rules, bidirectional throughput: 99 Mbps, maximum
Stealth mode, default firewall rules, bidirectional throughput: 50 Mbps, maximum.
IPsec (IETF standard)
Up to 250 VPN tunnels
DES | 3DES | AES-128/192/256
Router mode, default firewall rules, bidirectional throughput: 35 Mbps, maximum
Stealth mode, default firewall rules, bidirectional throughput: 25 Mbps, maximum
Web GUI (HTTPS) | command line interface (SSH) | SNMP v1/2/3 | central device man-
agement software
LEDs (Power 1 + 2, State, Error, Signal,
Fault, Modem, Info) signal contacts | ser-
vice contacts | log file | remote syslog
CE | FCC | UL 508
ANSI/ISA 12.12 Class I Div. 2
Realtime clock | Trusted Platform Module (TPM) | temperature sensor |
mGuard Remote Services Portal ready
mGuard rs4000/rs2000
mGuard rs2000
Freescale network processor with
330 MHz clocking
1 LAN port | 1 WAN port
Ethernet IEEE 802.3 10/100-BaseTX
RJ45 | full duplex | auto MDIX
Serial RS-232 | D-SUB 9 connector
2 digital inputs and 2 digital outputs
128 MB RAM | 128 MB Flash | SD card
Replaceable configuration memory
Not available
Voltage range 11 ... 36 V DC
2.13 W, typical
5% ... 95% (operation, storage), non-con-
densing
IP20
-20°C ... +60°C (operation)
-20°C ... +60°C (storage)
130 x 45 x 114 mm (up to DIN rail support)
722 g (TX/TX)
mGuard rs2000
IPsec (IETF standard)
Up to 2 VPN tunnels
DES | 3DES | AES-128/192/256
LEDs (Power, State, Error, Signal, Fault,
Modem, Info) signal contacts | service
contacts | log file | remote syslog
Innominate Security Technologies
31
Advertisement
Table of Contents
