Table of Contents
Advertisement
Objective
Action
I15007_en_02
2.8.2
Performing a recovery procedure
The network configuration (but not the rest of the configuration) is to be reset to the delivery
state, as it is no longer possible to access the device.
Use the recovery procedure in case you have forgotten the IP address under which the de-
vice can be accessed.
The following network setting is restored:
Table 2-4
Restored network setting
Network mode
Management IP #1
Router
The mGuard is reset to router mode with the fixed IP address.
–
The CIFS integrity monitoring function is also disabled because this only works when
the management IP is active.
–
In addition, MAU configuration is activated for the Ethernet connections. HTTPS ac-
cess is enabled via the local Ethernet connection (LAN).
–
The settings configured for VPN connections and the firewall are retained, including
passwords.
Possible reasons for performing the recovery procedure:
–
The device is in Router or PPPoE mode.
–
The device address has been configured and is not known.
–
The current IP address of the device is not known.
Up-to-date information on the recovery and flashing procedure can be found in the appli-
cation note for your firmware version.
You can find application notes under the following Internet address:
nate.com.
•
Slowly press the reset button six times.
After approximately two seconds, the Stat LED lights up green.
•
When the Stat LED has gone out, slowly press the reset button again six times.
If successful, the Stat LED lights up green.
If unsuccessful, the Err LED lights up red.
If successful, the device restarts after two seconds and switches to Router mode. The de-
vice can then be reached again under the corresponding address.
mGuard rs4000/rs2000 Switch
Management IP #2
https://192.168.1.1/
www.innomi-
Innominate Security Technologies
47
Advertisement
Table of Contents
